Cymodel DRASTIK 120

Lightweight plywood construction. Larger ailerons and elevator for extreme 3d performance.

This is an ARF and not a kit. Comes with complete hardware kit that includes- 3" foam wheels' fuel tank alum. landing gear that attaches with 3 screws, spinner, pushrods, tail wheel, etc.

Details are as follows:
Fuselage- Lite ply construction with lighting holes to save weight, Servo tray is installed and is located under the wing (1 servo for throttle, 1 servo for rudder ). Rudder is pull-pull system and only requires 1 servo. Requires 2 servos for the elevator halves and are mounted in the outside of the fuselage near and below the elevator halves. Firewall measures 4 1/2" wide and 5" tall. Landing gear attaches 7" back from firewall and uses 4 screws. Fuselage has a hatch located between wing and firewall with a spring loaded latch that lets you service the fuel tank (or batteries if you are using electric power)

Wing- 2 1/2 inches thick, 18 1/4" cord, symmetrical design, built up balsa design. has hardwood joiner and the 2 halves epoxy together. Uses 2 aileron servos for the ailerons (1 under each wing half). Ailerons are 28 1/4" by 3 3/4" each.

Tail Feathers - Flat (no airfoil and epoxies to fuselage) 10 1/8" cord including elevator halves. Horizontal stab. is 23 1/2" on leading edge tapering to 29 1/4" at rear (with elevator halves installed). Elevator halves are 11" by 4" each. Vertical stab. is 10 1/4" tall and 11" long tapering to 3 inches at the top (rudder not included). Rudder is 11 1/2" tall. Rudder is 5 inches at the bottom tapering to 2 1/5 inches at the top.

FLAPS- Sorry guys, no flaps

Recommended Throws- 45 deg. (up and down) for all surfaces

FEATURES:
Good quality Trainer
large wing area design for more lift
Top quality balsa & ply construction
Premium hand iron-on covering film
Comes with all parts, hardware and accessories

Specification:
Wingspan: 1980 mm
Wingarea: 87 dm2
Length: 1725 mm
Engine: 2stroke 1.20 cu.in
26cc gas engine
Radio: 4 Channles;6 Servos