ST Model BLAZE PNP
Description
Another stunning innovation from ST models, this Salto aerobatic glider not only performs superbly as a foam glider in its own right, it also features a retracting EDF unit!
Inspired by the ST Model DG1000 this Salto has a retracting EDF unit pre-installed and ready to use.
Using the supplied motor retraction controller, radio setup is easy and operation is even easier.
When you open the throttle the first 10% on your TX the controller raises the fan opening the doors as it goes and then arms the ESC allowing you to fly as a powered glider. The second you close the throttle below the 10% mark the ESC is disarmed and the motor is retracted into the fuselage.
You can also over-ride this using a 5th channel on a switch and keep the motor out for the whole flight if you choose.
The air frame itself features the clever design you expect from ST Models. Injection moulded in EPO and reinforced with carbon tube to ensure rigidity and strength.
The design is interlocking and quick to assemble. The tail planes are held on with two screws and the wings 'Twist & Lock' to the fuselage and are retained by simple catches.
Then simply connect the control wires to the horns with supplied screws. That's it, 5 screws!
Simply install a suitable RX and TX, charge and fit a 3S 11.1v 1800-2100mAh li-Po to get going.
Features:
56mm retracting EDF unit
Pre-programmed motor retraction & ESC controller.
Tough EPO construction
Easy wing attachment system
No glue required
Foam wheel to protect fuselage
Specifications:
LiPo: 3S 11.1v 1800-2100mAh (Rec.)
EDF Unit: 56mm 3-Blade (Inc.)
Electric Motor: Brushless (Inc.)
Length: 810mm
Radio: 4-5 Channel (Req.)
Servos: 4 (Inc.)
ESC: 40A Brushless (Inc.)
Weight: 880g (Approx.)
Wingspan: 1806mm
