E-flite 80-Amp Pro Switch-Mode BEC Brushless E

R3,199.00

80-Amp Pro Switch-Mode BEC Brushless ESC, EC5 (V2)
Features

    Up to 80 amps continuous current with proper air flow and 100 amps burst current (15 seconds)
    5V switch-mode BEC capable of 5 amps continuous current with 6 amps max burst on any recommended input voltage
    Drive up to 7 analog or 6 digital standard-sized servos with the BEC on any recommended input voltage
    3- to 6-cell Li-Po, 9- to 18-cell Ni-MH/Ni-Cd input voltage
    Programmable motor braking
    Safe power-arm mode prevents accidental starts
    Programmable low voltage cutoff with settings for 3-cell Li-Po (9.2V), 4-cell Li-Po (12V), 5-cell Li-Po (15V), 6-cell Li-Po (18V), or 74% of battery starting voltage
    Programmable throttle input range (1.1ms-1.9ms or 1.2ms-1.8ms)
    Programmable soft start-up rate - .25 second or 1 second
    Auto motor shut down if signal is lost or there is interference
    Programmable timing—5 user-selectable ranges-use with a large variety of brushless motors
    Two operating modes-Airplane or Heli
    Pre-wired connectors—E-flite EC5 on battery input and 4.0mm female gold bullets on motor output leads

Overview

When performance matters in your high-current applications look no further than the E-flite® 80-Amp Pro Switch Mode ESC. This is a high-quality, efficient sensorless brushless electronic speed control with an integrated Switch-Mode BEC. It can operate without the need for a separate receiver battery to power your servos and receivers, saving you weight and complication. It is capable of up to 80 amps continuous current when using 3- to 6-series Li-Po battery packs. You can drive up to 7 analog or 6 digital standard-sized servos with the BEC on any recommended input voltage. Featuring an exposed, finned heat sink aluminum case with lightweight plastic endcaps, safe power-arming along with advanced programmable features such as low voltage cutoff, braking, timing, throttle input range, and more, the E-flite 80-Amp Pro Switch Mode ESC is truly a 'pro series' electronic speed control.

This product is not intended for use by children under 14 years of age without direct adult supervision.

Specifications
    Type: Brushless
    Amperage: 60 & Up
    Input Connector Types: EC5, 10AWG leads
    Continuous Maximum Current: 75 - 100A
    Forward: Yes
    Brake: Yes
    Time Delay Brake: Yes
    Output Connector Types: 4mm Gold Bullet, 12AWG leads
    Momentary Peak Current: 100A (15 seconds) Proper Cooling Required
    Length: 3.0 in (77mm)
    Width: 1.6 in (41mm)
    Height: 0.62 in (15.5mm)
    Weight: 3.75 oz (106 g)
    BEC Voltage: 5.5V Switch-mode
    Overload Protection: Yes
    Cells w/BEC: 9-18 cells NiMH, 3-6S LiPo
    Auto Cutoff: Yes
    BEC Continous Current: 5A

  • Model:EFLA1080B 80-Amp Pro Swit